• REMOVE THE TRANSIT BOLTS BEFORE USING THE MACHINE FOR THE FIRST TIME. • First wash cycle without laundry: 1. Open the tap(s). Close the door. Pour a little detergent (about 100 ml) into the detergent compartment. Select a short wash programme (see programme chart). Press the “ON/OFF” button. This will remove any water remaining in the machine from the manufacturer’s test run. ROUTINE WASHES: 1. Open the tap(s). Sort the laundry according to fabric type and colour and load the machine. Close the door. Add detergent and any additives required. Select the programme, temperature and special options (depending on model). Press the “ON/OFF” button. 3 GB QUICK REFERENCE GUIDE INSTALLATION INSTRUCTIONS APPLIANCE AND ACCESSORIES PROTECTING THE ENVIRONMENT SAFETY INSTRUCTIONS MOVING AND TRANSPORTING THE APPLIANCE SORTING THE WASH DETERGENT AND ADDITIVES DYEING AND BLEACHING SELECTING THE PROGRAMME AND SPECIAL OPTIONS / PROGRAMME START DOOR LOCK / PROGRAMME END / PROGRAMME RESELECTION REMOVING THE FILTER / DRAINING RESIDUAL WATER CARE AND MAINTENANCE TROUBLE-SHOOTING GUIDE AFTER-SALES SERVICE PAGE 5 PAGE 10 11 11 11 12 13 14 PAGE PAGE PAGE PAGE PAGE PAGE PAGE 15 PAGE 16 PAGE 16 17 18 18 PAGE PAGE PAGE 4 INSTALLATION INSTRUCTIONS TRANSIT BOLTS The appliance is fitted with transit bolts to prevent internal damage while it is being moved. Before using the appliance the transit bolts MUST be removed (Fig. Slacken the bolts with the spanner supplied (Fig. Move the bolt to the centre of the hole. Completely extract the bolt and the coloured plastic spacer. Plug the hole using the plastic cap provided (Fig. Repeat the above operations for the other 3 bolts. Note Fit the transit bolts before transporting the appliance as follows: 1...