Скачать инструкцию



Фрагмент инструкции: руководство пользователя OREGON SCIENTIFIC RAR188A

Подробные указания по применению содержатся в руководстве пользователя.

2 3. 3 4. 4 5. MODE MEM CHANNEL 6. 5 6 7 8 7. 3 EN EN 1. Wall mount °C / °F Switch Alarm (On / Off) Press (up button) to increase or (down button) to decrease settings Battery compartment Catch to open battery compartment Table stand 1 3. 2 3 4 5. 5 7. REMOTE SENSOR (THN122) 6 4 GETTING STARTED 1 1 2 3 4 1. LED Status indicator 1. Wall mount hole RESET Channel number (1 - 3) Battery compartment (Battery compartment cover not shown) 5 EN EN BATTERIES Batteries are not supplied with this product. You will need to purchase 2 x UM-3 (AA) 1. 5V alkaline batteries for the main unit, and 2 x UM-4 (AAA) 1. 5V alkaline batteries for the remote sensor. Insert batteries before first use, matching the polarity as shown in the battery compartment. For best results, install batteries in the remote sensor before the main unit. Press RESET after each battery change. Do not use rechargeable batteries. shows on LCD display when batteries are low. NOTE CHANGE SETTINGS 1. Press and hold MODE for 2 seconds to enter setting mode. Press UP or DOWN to change settings. Press MODE to confirm. on a wall with a nail. REMOTE SENSOR (THN122) This product is shipped with a THN122 Thermo Sensor that collects Temperature data. Data can be collected from up to 3 sensors. Additional sensors sold separately. SETUP SENSOR TABLE STAND OR WALL MOUNT Product can stand on detachable base or be mounted Open the remote sensor battery compartment with a 6 small Phillips screwdriver. Insert the batteries, matching the polarity as shown in the battery compartment. Set the channel. The switch is located in the battery compartment. temperature unit before you mount the sensor...
Copyright © 2005 - 2012 - Diplodocs - Все права защищены.
Торговые марки принадлежат их соответствующим владельцам.