(1) Turn off the main power switch located on the back of the FT-2000 (or turn off the power supply for FT-2400H-3 and wait a minute, until the capacitors discharge) and remove the AC power cord. (2) (3) Connect the CT-119 Cable's DB9F connector to the serial port COM1 in the back of your computer. If you use a USB to serial adapter, you might need to change the COM Port number. Now go to the desktop open PEP2000_MAIN folder and find the FSW003 icon as shown below. Double-click the FSW003 icon, displayed on the Program Screen. NOTE: If you receive a "communications error" message on your screen, click on the Configure box and choose a different COM port from the drop down menu. Then click the WRITE button again. (4) (5) When the program opens, confirm that the file AH025_V0151. SFL is highlighted; if not, click on it to highlight it. Remove the black cover from the PGM jack (bottom left on the rear panel). Plug the mini-DIN connector of the CT-119 into the PGM jack. Be sure that the arrow indicator on the mini-DIN plug is down. Plug the AC cord into the radio and turn the main power switch on the back of the radio to the ON position. [NOTE: The radio will not show a display now. ] Main Power SW PGM Click on [WRITE] in the program window. A status bar with green bars should appear below the [WRITE] button. Note disregard the on screen instruction to [3. Turn "S3004" on]. (7) When the loading process is complete, an [OK?] box will appear. Click [OK?]. (8) Turn off the main power switch, (or turn off the power supply for FT-2400H-3 and wait a minute, until the capacitors discharge) and unplug the AC power cord. (9) Unplug the CT-119 from the radio. (10) Plug the AC power cord into the radio and turn the main power switch on the back of the radio to the ON position (or turn on the power supply for FT-2400H-3). (11) Plug the radio back in...