3 Installation Positioning the appliance en Positioning the appliance in the desired location. The appliance is equipped with water supply and drain hoses that can be positioned to the right or the left of the appliance to facilitate proper installation. Levelling the appliance Once the appliance is positioned, adjust the feet (screwing them in or out) to level the appliance. If the appliance is level, it will help to ensure proper performance. Cold water connection Connect the water supply hose to a threaded 3/4 inch (ca. 19mm) connector, making sure that it is fastened tightly in place (see Fig. If the water pipes are new or have not been used for an extended period of time, let the water run for a while until the water is clear and free of impurities. If this precaution is not taken, there is a risk that the water inlet can get blocked and damage the appliance. A Warning The appliance is to be connected to the mains water using new hose sets. Old hose sets should not be reused. B Anti-Flooding protection The dishwasher is equipped with a system that stops the supply of water in the event of a problem with the water supply hose or leaks within the unit, in order to prevent damage to your home. If for any reason the box containing the electrical components happens to get damaged, turn off the power supply and unplug the appliance immediately. In order to guarantee that the anti-flooding feature operates properly, box "A" with the water supply hose must be attached to the water supply tap as shown in Fig. If the length of the hose is not adequate to make a proper connection, the hose must be replaced with one which is long enough. This hose is available upon request from specialised retailers and approved service centres. 4 en Drain hose connection Insert the drain hose into a drain pipe with a minimum diameter of 4cm, making sure to avoid kinking or pinching...