Please see the DMU-2000 Data Management Operation Manual for the procedure to save your settings to a CF card. (1) (2) (3) Turn off the main power switch located on the back of the FT-2000 (or turn off the power supply for FT-301 and wait a minute, until the capacitors discharge) and remove the AC power cord. Connect the CT-119 Cable's DB9F connector to the serial port COM1 in the back of your computer. If you use a USB to serial adapter, you might need to change the COM Port number. Now go to the desktop open PEP2000_MAIN folder and find the FSW003 icon as shown below. Double-click the FSW003 icon, displayed on the Program Screen. NOTE: If you receive a "communications error" message on your screen, click on the Configure box and choose a different COM port from the drop down menu. Then click the WRITE button again. (4) (5) When the program opens, confirm that the file AH025_V0150. SFL is highlighted; if not, click on it to highlight it. Remove the black cover from the PGM jack (bottom left on the rear panel). Plug the mini-DIN connector of the CT-119 into the PGM jack. Be sure that the arrow indicator on the mini-DIN plug is down. Plug the AC cord into the radio and turn the main power switch on the back of the radio to the ON position. [NOTE: The radio will not show a display now. ] Main Power SW PGM (6) Click on [WRITE] in the program window. A status bar with green bars should appear below the [WRITE] button. Note disregard the on screen instruction to [3. Turn "S3004" on]. When the loading process is complete, an [OK?] box will appear. Click [OK?]. Turn off the main power switch, (or turn off the power supply for FT-301 and wait a minute, until the capacitors discharge) and unplug the AC power cord. (9) Unplug the CT-119 from the radio...