Скачать инструкцию



Фрагмент инструкции: руководство пользователя WHIRLPOOL LVI-100-IX

Подробные указания по применению содержатся в руководстве пользователя.

go to step 1 (see “Daily check”) if water is HARD extra salt needs to be added (go to step 1, “Daily check”) Filling the salt reservoir - Dissolve limescale (not necessary if water hardness level is set to “soft”!) 3 2 1 7 8 Daily check Screw on the cap. Salt residual around the cap need to be removed. Some salt reservoir have a level indicator integrated in the cap (see below how to check). Visual indicator (depending on the model). Unscrew cap. 5 6 1- salt reservoir 2- rinse aid dispenser 3- detergent dispenser 4- racks system 5,6,7,8- available functions on the panel 9- filters 10- spray arms Fill the salt reservoir with water before the first wash only. Add salt (never add detergent!) min. 8 kg / max. 1 kg Once regeneration salt is added, immediately start a wash program (the “Pre-wash” program alone is not sufficient). Residual saline solution or grains of salt can lead to deep-down corrosion, irreparably damaging the stainless steel components. The guarantee is not applicable if faults are caused by such circumstances. (depending on the model) The salt level indicator lamp may remain lit Salt indicator on the control panel at the end of several wash cycles. If the The indicator lamp lights up when SALT water hardness level falls within category NEEDS TO BE ADDED. (soft), no salt is required. Salt indicator on the salt reservoir cap green: OK. clear: NEEDS TO BE ADDED GB -2- Adding rinse aid (not necessary when you use tablets). How to adjust the rinse aid dosage regulator Daily check The rinse aid dosage can be adjusted to the detergent used. The lower the setting, the less rinse aid is dispensed (factory setting: position 4). Press the button to open the cover B...
Copyright © 2005 - 2012 - Diplodocs - Все права защищены.
Торговые марки принадлежат их соответствующим владельцам.