0 Water (l) 59* 49 37 54 37 50* 46 56 50 45 40 55 45 45 Energy (kWh) without “Rapid” 1. 50 Approx. programme duration (hours : minutes) without “Rapid” with “Rapid” 2:00 4:00 2:20 2:45 2:30 1:30 1:15 1:29 0:45 1:00 0:30 0:45 0:40 0:36 2:30 *** 1:45 *** 1:09 0:54 1:08 - “Spin” button • Every programme has a predefined spin speed. • Press the button to set another spin speed. • If spin speed “0” is selected, the final spinning is cancelled but intermediate spin peaks remain during rinse. The water is drained out only. “Rapid” button • Enables quicker washing by shortening the programme duration. • Recommendable for small loads or only lightly soiled laundry. START DELAY FAILURE INDICATIONS In case of any failures or irregularities, consult the “Troubleshooting Guide” in your Instructions for Use. “Service” Lighting up of the “Service” indication can be caused by a fault in an electrical component. “Water tap closed” The washing machine has no or insufficient water supply; the water tap might be closed or the water inlet hose kinked. “Clean pump” Waste water is not pumped out. The drain hose may be kinked or the filter must be cleaned (see “Cleaning the filter” in your Instructions for Use). PROGRAMME END Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. Water and energy consumption refer to the default setting of the programmes; selecting special options or modifying spin speed or temperature will change the consumption data...