0107 in) ERRORS FOUND IN THE PROGRAMMINGMANUAL (REF. 9701) Page 64. Function G51. When working in diameters, the "I" value in the table is in diameters and the value to be assigned to parameter "I" in the G51 function must always be given in radius. Section 12. (Chapter 12 page 133) Nesting levels. The figure reads M02 ó M30 It should read: M02 or M30 TING MANUAL (REF. 9701) ERRORS FOUND IN THE OPERA Page 46. Last paragraphs. It should say: The CNC asks which is the source program number and which is the new program number, after keying each one of them, press [ENTER]. If the number of the source program does not exist, or there is already a program in memory with the same number as the new one or if there is not enough when copying the new program , the CNC will issue a message indicating the cause. ALLATION MANUAL (REF. 9707) ERRORS FOUNDS IN THE INST Section 5. 4 (chapter 5 page 7) Machine parameters for spindle control: Parameter P606(3) is missing: P606(3) Spindle counting direction It sets the spindle counting direction. If correct, leave it as it is or change it if otherwise. Possible values: "0" and "1". MODIFICATIONS TO THE INSTALLATION MANUAL (REF. 9707) Section 2. 4 (chapter 2 page 9). Logic Outputs: In the table, the following output is missing: Output "C" Row 1: (pin 3 I/O 1) M strobe Row 2: (pin 5 I/O 2) output 3, decoded M function Section 3. 3 (chapter 3 page 11). P602(4). Another example: Having a Fagor electronic handwheel (25 lines per turn) set as follows: P602(1)=0 Millimeters P501=1 Resolution 0. 001 mm. P602(4)=0 x4 Multiplication factor Depending on the position of the MFO switch (Manual Feedrate Override), the selected axis will move: Position 1 1 x 25 x 4 = 0. 100 mm per turn Position 10 10 x 25 x 4 = 1. 000 mm per turn Position 100 100 x 25 x 4 = 10. 000 mm per turn MODIFICATIONS TO THE LAN MANUAL (REF. 9701) Section 2. 2 (page 3). P616(7) The first 2 paragraphs change...