Directives: -73/23 - 90/683 (Low Voltage Directive); -89/336 (Electromagnetical Compatibility Directive); -93/68 (General Directives) and subsequent modifications. 4 Description of the Hob 1 3 4 5 2 2 Fig. 1 6 1. Hob Top 2. Semi-rapid burner 3. Auxiliary burner 4. Rapid burner 5. Ultra-rapid burner (triple crown) 6. Control knobs Installation Any gas installation must be carried out by a registered CORGI installer, and in accordance with existing rules and regulations. The relevant instructions are to be found in the second section of this manual. Please, ensure that, once the hob is installed, it is easily accessible for the engineer in the event of a breakdown. WHEN THE HOB IS FIRST INSTALLED Once the hob has been installed, it is important to remove any protective materials, which were put on in the factory. 5 Hob burners control knobs The symbols on the knobs mean that : there is no gas supply there is maximum gas supply there is minimum gas supply Operation Fig. 2 Lighting the burners For easier lighting, proceed before putting a pan on the pan support. To light a burner, turn the relevant knob anticlockwise to FO 0204 maximum position ( ), then push it down to ignite the A - Burner cap burner. Upon ignition, adjust the flame as required. If the burner does not ignite, turn the control knob to zero, B - Burner crown C - Ignition electrode and try again. When switching on the mains, after installation or a power cut, it is quite normal for the spark generator to be activated automatically...