As long as a wash programme is running, the door remains locked and must on no account be forced open. In case you have an urgent need to open it during a running programme, refer to “Cancel (Reset) a running programme before the end”. RED INDICATIONS “Service” Lighting up of the “Service” indication can be caused by a fault in an electrical component. Refer to the “Troubleshooting Guide” in your “Instructions for Use”; if the fault persists, contact our After Sales Service. “Water tap closed” The appliance has no or insufficient water supply. Open the water tap; if the indication still lights up, refer to the “Troubleshooting Guide” in the Instructions for Use. “Clean pump” Waste water is not pumped out. Check whether the drain hose is kinked or the filter must be cleaned; in the latter case refer to the Instructions for Use (“Removing the Filter”). PROGRAMME END • All the lights of the programme sequence indicator are off, and the “Door open” indication lights up. Turn the programme selector to the “Off/O” position. Close the water tap. Open the door and unload the machine. Leave the door ajar to allow the drum to dry. CHANGE PROGRAMME AND/OR OPTIONS AFTER PROGRAMME START 1. Press the “Start (Pause)” button to pause the programme. The light flashes. Select the new programme (with temperature), any options and another spin speed if you want. Press the “Start (Pause)” button again. The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. CANCEL (RESET) A RUNNING PROGRAMME BEFORE THE END The “Reset” button cancels a programme before the end. • Press the “Reset” button for at least 3 seconds. Any existing water is drained out before the door can be opened. Consumption values were measured in normalized conditions in compliance with Standard IEC/EN 60 456...