Warning: To prevent rust from forming, we advise you to load the salt before starting a wash cycle. Adjusting Salt Consumption The dishwasher is designed to allow for adjusting the amount of salt consumed based on the harness of the water used. This is intended to optimize and customize the level of salt consumption so that it remains at a minimum. Your Local Water Board can supply the degree of hardness of the water in your area. To adjust salt consumption, proceed as follows: 1) Unscrew the cap from the salt container. 2) There is a ring on the container with an arrow on it (see figure to the side), if necessary, rotate the ring in the anticlockwise direction from the "_" setting towards the "+" sign, based on the hardness of the water being used. It is recommended that adjustments be made in accordance with the following schema: Water Hardness Salt Autonoconsumy mption (cycles\2(grams/kg) cycle) 0 20 40 60 / 60 40 25 Clarke degrees °fH mmol/l Selector position 0 - 14 14 - 36 36 - 71 >71 0 - 17 18 - 44 0 -1,7 1,8 - 4,4 / "-" MED "+" 45 - 89 4,5 - 8,9 > 89 > 8,9 3 GB Detergent and Rinse Aid. Detergent Detergent specifically intended for use with dishwashers must be used. The dispenser must be refilled before the start of each wash cycle following the instructions provided in the "Wash Cycle Table. " The detergent dispenser is located on the inside panel of the door. Loading the detergent To open lid "A", press button "B". The cleaning detergent should be introduced into the two containers "C"and "D" up to the rim. After pouring in the detergent, replace the lid, pressing down until it clicks. Dishwasher detergent in tablets is now available on the market, in which case you should place one tablet into container "D" and replace the lid. Notice: To facilitate closing the cover, remove any excess detergent on the edges of the dispenser...