! The cable must not be bent or compressed. ! The cable must be checked regularly and replaced by authorised technicians only (see Assistance). ! The manufacturer declines any liability should these safety measures not be observed. Changing the plug: Removing the plug If your appliance has a non-rewireable moulded plug and you should wish to remove it to add a longer cable or to re-route the mains cable through partitions, units etc. please ensure that either: The plug is replaced by a fused 13amp rewireable plug bearing the BSI mark of approval. or The mains cable is wired directly into a 13amp cable outlet, controlled by a switch (in compliance with BS 5733) which is accessible without moving the appliance. Disposing of the plug Cut off and dispose of the supplied plug if it does not fit your socket. The cable should be cut as close as possible to the moulded plug. Remove the fuse. 2 WARNING: To avoid a shock hazard do not insert the discarded plug into a socket anywhere else. Reversible doors GB Fitting a new plug IMPORTANT: WIRES IN THE MAINS LEAD ARE COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE. Green and Yellow Blue Brown - Earth - Neutral - Live 1 2 As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: - Connect Green and Yellow wire to terminal marked or coloured Green and Yellow. 'E' or - Connect Brown wire to terminal marked 'L' or coloured red or brown. - Connect Blue wire to terminal marked 'N' or coloured Black or Blue. If a 13amp plug (BS 1363) is used it must be fitted with a 13amp fuse. If you are in any doubt about the electrical supply to your machine, consult a qualified electrician before use...