To switch off your TomTom ONE, press and hold the On/Off button for 2 seconds. Setting up You have to answer a few questions to set up your TomTom ONE. Answer the questions by tapping the screen. You will use the touchscreen for everything you do with your ONE. You can change these settings at any time using the Preferences menu. For information about the Preferences menu, see Preferences on page 29. Once you have answered the questions, your ONE will display the Driving View. The Driving View is shown in black and white until your ONE locates your current position. For more information about the Driving View, see Driving View on page 13. Locating your current position Your TomTom ONE must be outdoors to locate your current position. The first time you start your ONE, it can take up to 5 minutes to find your current position. If it takes longer than 5 minutes, make sure that you are in an open place without tall buildings or trees around you. In the future, your position will be found much faster, normally within a few seconds. Once your ONE has located your current position, the Driving View is shown in full colour and shows your position on the map. 5 Note: Your TomTom ONE does not transmit your position. You can however send your position to TomTom Buddies. For more information, visit www. tomtom. com/plus Note: Some vehicles have a heat reflective shield embedded in the windscreen, which may prevent TomTom ONE from locating your current position. If this is a problem in your vehicle, use the TomTom External Antenna Kit (available as an accessory). 6 Chapter 4 Making your first journey Making your first journey Planning a route with TomTom GO is very simple. To plan your first route, follow the steps below. Note: You should always plan your journeys before you start driving. It is dangerous to plan routes when you are already moving. Tap the screen to bring up the main menu. Tap Navigate to...