Filling the salt reservoir - Dissolve limescale (not necessary if water hardness level is set to “soft”!) Daily check Screw on the cap. Salt residual around the cap need to be removed. Some salt reservoir have a level indicator integrated in the cap (see below how to check). 1 1- salt reservoir 2- rinse aid dispenser 3- detergent dispenser 4- racks system 5,6,7,8- available functions on the panel 9- filters 10- spray arms Visual indicator (depending on the model). Unscrew cap. Fill the salt reservoir with water before the first wash only. Add salt (never add detergent!) min. 8 kg / max. 1 kg Salt indicator on the salt reservoir cap green: OK. clear: NEEDS TO BE ADDED (depending on the model) The salt level indicator lamp may remain lit Salt indicator on the control panel at the end of several wash cycles. If the The indicator lamp lights up when SALT water hardness level falls within category NEEDS TO BE ADDED. (soft), no salt is required. GB -2- Adding rinse aid (not necessary when you use tablets). How to adjust the rinse aid dosage regulator Daily check The rinse aid dosage can be adjusted to the detergent used. The lower the setting, the less rinse aid is dispensed (factory setting: position 4). Press the button to open the cover B. Using a coin or similar object, turn the arrow to the desired setting. After adjusting the rinse aid setting, shut the cover again. 2 Visual indicator If required, open the cover B (press the dedicated button). Add rinse aid to the max. line ~150 ml Check the rinse aid indicator to check the level into the dispenser. (depending on the model) Rinse aid indicator on the control panel The indicator lamp lights up when RINSE AID NEEDS TO BE ADDED...