Symbol Explanation Shows the selected channel number. Displays when the volume of radio is being adjusted higher or lower. Display when the Key Lock is activated. Shows the selected CTCSS code number. Indicates the Automatic Power Off mode is activated. Displays when your radio is transmitting or the CALL function is set. Displays when your radio is receiving a signal. Symbol Setting Channel CTCSS VOX Description Selects channel for transmission Selects a CTCSS code for the current channel Enable/disable voice-activated transmission You can directly charge Ni-MH rechargeable batteries without taking batteries out from the battery compartment by using an optional 2-bay cradle charger (sold separately). You can recharge up to two radios at the same time. The LED on the cradle charger will light green when the transceivers are charging. Complete charging takes about 14 to 16 hours. Located inside the transceiver's battery compartment is a charging switch, which enables the recharging of batteries. When placed on the cradle. The switch must be set to `ON' when rechargeable batteries are used and recharged using the cradle. If alkaline batteries are used, the switch should be set to `OFF'. WARNING: Do not put transceivers into the charger when using alkaline batteries. CAUTION: The cradle charger does not automatically switch off after the batteries have been fully recharged. As such, there is a danger of overcharging, which may shorten the batteries' lifespan heavily. English OWNER'S MANUAL TP-329 3. Roger Beep Enable/disable beep heard after the finish of a received transmission Key Tone Automatic Power-Off Enable/disable beep when a key on the trans ceiver is pressed Enable/disable automatic shut-off after device is idle for 2 hours INTRODUCTION Thank you for selecting the Oregon ScientificTM TP329 as your product of choice. This product is a portable, easy-to-use two-way radio transceiver...