priate waste handling of this product. For more detailed infor· This washing machine is heavy. Take care when moving it. mation about recycling of this product, please contact your local · You must remove the packing on the washing machine before city office, your household waste disposal service or the shop use. Failure to remove all transport protection devices can where you purchased the product. cause damage to the washing machine or nearby furniture. 146 8377 00 - 04/05 1 3. INSTALLATION 3. Unpacking Packing used to protect internal parts of the washing machine during transport must be removed before the washing machine is put into service for the first time. Remove all packing from the washing machine. Tilt the washing machine sideways and then remove the packing under the motor, and straighten the washing machine. Leveling Precise leveling will prevent vibrations, noise and movements of the washing machine during operation. Make the washing machine level by adjusting the leveling screw that is too short. Unscrew the stand and locking collar assembly (lift the washing machine if necessary). Tilt the washing machine backwards, rotate it by a quarter of a turn on one of its corner to remove the transport base. When the washing machine is stable, maintain the stand on the ground and turn the locking collar as far as posible. Water inlet Open the washing machine lid and remove the immobilization packing and plastic films. Close the lid. Please install the water inlet hose onto the back of your washing machine: - Insert the seal in the hole at the bottom of the back panel (fig. - Screw on the bottom fitting of the water inlet hose as shown in fig. 2 and fig. Use a 10 mm spanner to remove the two screws and spacers at the back. - Connect the feed hose connector onto the water inlet tap, taking care to position the gasket correctly. - Turn on the water inlet tap...