The power supply cord must be positioned so that it does not reach a temperature in excess of 50°C above room temperature at any point. ! The installer must ensure that the correct electrical connection has been made and that it is compliant with safety regulations. Before making the actual connection, make sure that: • The fuse and electrical system can withstand the load required by the appliance; • That the electrical supply system is equiped with an efficient earth hook-up according to the norms and regulations prescribed by law; • That the plug or switch is easily accessible. ! The wires in the mains lead are coloured in accordance with the following code: Green & Yellow - Earth Blue - Neutral Brown - Live As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: Connect the Green & Yellow wire to the terminal marked “E” or or coloured Green or Green & Yellow. Connect the Brown wire to the terminal marked “L” or coloured Red. Connect the Blue wire to the terminal marked “N” or coloured Black. ! The cable must not be bent or compressed. ! The cable must be checked regularly and replaced by authorised technicians only (see Assistance). ! The manufacturer declines any liability should these safety measures not be observed. GB Clamp Position for H=40mm top 40 Back ! Use the clamps contained in the "accessory kit. " • In the event the cooktop is not installed above a built-in oven, a wood panel must be inserted as insulation. This panel must be placed at least 20 mm from the bottom of the cooktop itself...