• The socket must have an earth connection. • The socket must be able to withstand the machine’s maximum power output as indicated on the data plate (see Description of the tumble dryer). • The power supply voltage must fall within the values indicated on the data plate (see Description of the tumble dryer). • The socket must be compatible with the dryer’s plug. Should this not be the case, replace the plug or the socket.  Do not use extension cords.  The dryer must not be installed outdoors, even if the space is sheltered. It can be very dangerous if exposed to rain or storms.  Once installed, the dryer’s electrical wire and plug must be within reach.  The power cord must not be bent or squashed.  The power cord is supplied fitted with a BS1363 plug and with a 13 amp BS1362 fuse. If it is necessary to fit a replacement fuse, it must be a 13 Amp ASTA approved to BS1362 type. WARNING: The plug must not be used without a fuse cover. If a replacement fuse holder/cover is required, it must be of the same colour coding or wording as shown on the base of the plug. Replacements are available from authorised dealers. Moulded plug 15 mm 15 mm Ventilation • The room must be adequately ventilated while the dryer is running. Make sure that the dryer is installed in a room free of humidity and with adequate air circulation. The flow of air around the dryer is essential to allow water to condense during drying; the dryer will not function properly if it is placed in an enclosed space or inside a cabinet.  Some condensation may form if the dryer is used in a small or cold room.  We do not recommend that the dryer is installed in a cupboard but the dryer must never be installed behind a lockable door, a sliding door or a door with a hinge on the opposite side to that of the dryer door...