The indications for consumption given on the data plate have been calculated for this type of installation. PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24 4 575-585 mm. 547 mm. Electrical Connection The electrical connection to the mains must be made on the appliance. The power voltage and frequency are as indicated on the rating plate. ! THIS APPLIANCE MUST BE EARTHED. Fitting the power supply cable 1. Open the terminal board by inserting a screwdriver into the side tabs of the cover. Use the screwdriver as a lever by pushing it down to open the cover (see diagram). Install the power supply cable by loosening the cable clamp screw and the three wire contact screws L-N. Connect the wires to the corresponding terminals: the Blue wire to the terminal marked (N), the Brown wire to the terminal marked (L) and the Yellow/Green wire to the terminal marked (see diagram). Unplug the appliance before all operations, even when replacing the oven lamp. Using the appliance without correct earthing is highly dangerous. ! After connecting the appliance to the flexible cable, tighten all the screws on the terminal board. APPLIANCE SPECIFICATIONS Dimensions* Volume* Dimensions** Volume** Electrical connections width 43. 5 cm height 32,4 cm depth 40. 3 cm 57 l width 45. 5 cm height 32,4 cm depth 40. 3 cm 60 l voltage: 230-240V~ 50/60 Hz maximum power absorbed 2800-3000 W Directive 2002/40/EC on the label of electric ovens...