For proper ventilation of the appliance, you must leave: - a space of at least 10 cm between the top part and any cabinets above it; - a space of at least 5 cm between the sides of the appliance and any adjacent cabinets/walls. To install the appliance between furniture units, please follow the instructions provided on the attached sheet. Earthing Before making the electrical connection, check that the voltage shown on the data plate, that you will find on the bottom left hand side of the appliance next to the crisper, corresponds to that of your home and that the socket is earthed in compliance with all current electrical regulations. If the system is not earthed, the manufacturer declines all liability for consequent damages or losses. Do not use adapters or multiple sockets. Check the power load The electrical socket must support the maximum power load of the appliance shown on the data plate (on the bottom left hand side of the appliance next to the crisper). Before plugging the appliance to the mains Stand the appliance upright and wait at least 3 hours before plugging the appliance into the mains to ensure proper performance. Away from Heat Avoid positioning the appliance in a place where it is directly exposed to sunlight or near an oven, cook top or the like. 1 GB Electrical connection Your appliance is now supplied with a 13 amp fused plug that can be plugged into a 13 amp socket for immediate use. Before using the appliance please read the instructions below. WARNING - THIS APPLIANCE MUST BE EARTHED. THE FOLLOWING OPERATIONS SHOULD BE CARRIED OUT BY A QUALIFIED ELECTRICIAN. Replacing the fuse: When replacing a faulty fuse, a 13 amp ASTA approved fuse to BS 1362 should always be used, and the fuse cover refitted. If the fuse cover is lost, the plug must not be used until a replacement is obtained...