! The cable must not be bent or compressed. ! The cable must be checked regularly and replaced by authorised technicians only (see Assistance). ! The manufacturer declines any liability should these safety measures not be observed. 2 Fitting a new plug IMPORTANT: WIRES IN THE MAINS LEAD ARE COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE. Green and Yellow Blue Brown - Earth - Neutral - Live GB As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: - Connect Green and Yellow wire to terminal marked or coloured Green and Yellow. 'E' or - Connect Brown wire to terminal marked 'L' or coloured red or brown. - Connect Blue wire to terminal marked 'N' or coloured Black or Blue. If a 13amp plug (BS 1363) is used it must be fitted with a 13amp fuse. A 15amp plug must be protected by a 15amp fuse, either in the plug or adaptor or at the distribution board. If you are in any doubt about the electrical supply to your machine, consult a qualified electrician before use. CE Marking certifies that this appliance conforms to the following EEC directives : Low Voltage Equipment - 73/23/EEC & 93/68 EEC Electromagnetic Compatibility 89/336/EEC, 92/31/EEC & 93/68/EEC 3 GB Reversible doors Warning: Before attempting to remove the door, switch off the electrical supply and pull out the mains plug. It is recommended that you remove any loose items/fittings from inside the appliance and place food into insulated containers whilst carrying out this operation. You may require assistance to carefully lay the appliance onto its back onto suitable protective materials (i. original packaging). Remove the door 1. Lay down the appliance on its back. Unscrew, remove and retain the bottom hinge pin. Slightly open the door and slide downward, remove and carefully place to one side...