Turn the programme selector to the “Off/O” position. Close the water tap. Open the door and unload the machine. Leave the door ajar to allow the drum to dry. CHANGE PROGRAMME AND/OR OPTIONS AFTER PROGRAMME START Before starting and after end of a programme, the lamp lights to show the the door can be opened. As long as a wash programme is running, the door remains locked and must on no account be forced open. In case you have an urgent need to open it during a running programme, refer to “Cancel (Reset) a running programme before the end”. FAILURE INDICATIONS Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. Water and energy consumption refer to the default setting of the programmes; selecting special options or modifying spin speed or temperature will change the consumption data. The programme duration may differ from the values indicated above as it depends on the operation conditions applicable at that time (see also “Troubleshooting Guide” in your Instructions for Use). * To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ** Reference programmes for Energy Label. In case of any failures or irregularities, consult the “Troubleshooting Guide” in your Instructions for Use. “Service” Lighting up of the “Service” indication can be caused by a fault in an electrical component. “Water tap closed” The washing machine has no or insufficient water supply; the water tap might be closed or the water inlet hose kinked. “Clean pump” Waste water is not pumped out...