FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED. (see at right for options description) Options and display description SALT INDICATOR When lit (at the end of the cycle), the salt reservoir needs to be refilled. RINSE AID INDICATOR When lit (at the end of the cycle), the rinse aid dispenser needs to be refilled. PROGRAM SELECTION BUTTON Push “Programs” button (repeatedly) until the indicator of the required program lights up (see “Table of programs” below). START/RESUME BUTTON Push this button to start the selected program: the indicator lights up and goes off at the end of the program. When the door is opened during a washing cycle, the cycle is temporarily paused: the Start indicator blinks. To resume the cycle push the Start button and close the door within 3 seconds. CANCEL/OFF BUTTON Push this button to switch off the control panel. If pressed when a program is running it cancels the program ongoing draining water for 1 minute. If pressed when the dishwasher is switched off it drains any possible liquids from dishwasher (1 minute process). If the indicator flashes repeatedly, see page 6 chapter ”What to do if. Table of programs Consumption Loading instructions Detergent Litres kWh Minutes 1) Drying Phase P 1 2 3 4 5 1) 2) 3) Programs Pre-Wash cold Available options Delay Crockery to be washed later. — 4. 03 14 NO Rapid 45°C Delay Lightly soiled crockery, with no driedon food. Normally soiled crockery. Energy-saving program. Normally or heavily soiled crockery, with additional antibacterial wash. Program interruption (e. due to door opening) can compromise elimination of germs...