Do not submit it to torsion or stress. It must not be choked or have sharp bends. - Fix the gas hose by means of the appropriate clamps positioned on the cooker rear panel, at the bottom. It should be replaced periodically. Make sure to replace the flexible hose before the expiry date marked on the hose itself. Both ends must always be secured by means of a hose clamp F (Fig. Important Position the pipe as illustrated in Fig. The pipe must be as short as possible (max: 2 m for natural gas and 1. 5 m for butane and propane) but must not come into contact with the back or side wall of the cooker. Respect the assembly and use conditions described in the instruction of the connecting tube or pipe and make sure that the assembly is leak-tight. Adjustment to different types of gas If the appliance is intended to operate with a different gas from the supply gas, proceed as follows: - change the injectors; - adjust the minimum flow; - replace the connector if necessary, in accordance with your local specific standards; - adjust primary air for oven; - adjusting or replacing of gas pressure regulator if it is installed; - replace old sticker “adjusted for gas. " by new one, which is supplied with nozzles. 1 Sealing ring Rigid pipe Sealing ring Flexible tube Fig. A Fig. B Connector Sealing ring Threaded union Connector Butane Propane Natural gas Hose clamp Gas tube Fig. C 19 INSTALLATION INSTRUCTIONS COOKER TOP Adaptation to different gas types Lift off the grid plate, cups and flame distributors. The injector is now accessible. Unscrew the injector A (Fig. 1) and replace it with the injector of the diameter appropriate for the burner and gas to be used, in accordance with Injector Table relevant to the country. Following each new adaptation to a different gas type, change the information label relating to the supply gas...