Фрагмент инструкции: руководство пользователя WHIRLPOOL AWA-1000Подробные указания по применению содержатся в руководстве пользователя. Remove the packaging and check
a. Cut and remove the shrink-wrap. Remove the top protection and the protective corners. Remove the bottom protection by tilting and turning the appliance on one rear bottom corner. The appliance is fitted with transport screws and a transport bracket to prevent damage during transport. Before using the washing machine you must remove the transport bracket (see Installation/Remove the transport bracket). Do not forget to screw back 4 screws to the rear panel by which was fixed the transport bracket - to avoid noisy and vibration of the machine. Electrical connection
2. Remove the transport bracket
3. Install the washing machine
Place the appliance on a flat and stable floor surface. Adjust the feet to ensure that the machine is stable and level (see Installation/Adjust the feet). Water supply
Connect the water supply inlet hose in accordance with the regulations of your local water company (see Installation/Connect the water inlet hose). Water supply: Cold water only Tap: 3/4 threaded hose connection Pressure: 100-1000 kPa (1-10 bar). For Great Britain & Ireland only: Water inlet: hot and cold fill. The warm water inlet temperature must not exceed 60° C.
5. Drain hose
Connect the drain hose to the siphon or hook it over the edge of a sink with the U bend (see Installation/Connect the water drain hose). If the washing machine is connected to a builtin drainage system, ensure the latter is equipped with a vent to avoid simultaneous loading and draining of water (siphoning effect)... |
Copyright © 2005 - 2012 - Diplodocs -
Все права защищены. Торговые марки принадлежат их соответствующим владельцам. |