OVERVIEW Programme selection button Press the button (repeatedly) until the indicator lamp of the desired programme lights up (see table 1. At the end of the wash cycle, the last programme selected is memorized. Half Load/Multizone Load the upper or lower rack only. Factory setting = Wash upper and lower rack (both indicator lamps light up) Press once = Wash lower rack (the indicator lamp lights up) Press twice = Wash upper rack (the indicator lamp lights up) At the end of the programme, the most recently selected setting remains memorised. If the upper rack is not being washed, the “Wash lower rack” indicator lamp should be lit. Antibacterial rinse 3) This function activates an antibacterial rinse at the end of the wash cycle, guaranteeing a further reduction of bacteria. Press the button to activate or deactivate the function. This function can be used with those programmes marked with the relative symbol in table 1. The dishwasher door must be kept shut for the entire duration of the programme in order to guarantee reduction of bacteria. If the door is opened the indicator lamp starts flashing. At the end of the programme, the most recently selected setting remains memorised. Detergent setting upon initial use and when using a different type of detergent Indicator lamp off = Powder/gel detergent (factory setting). If using combined detergents, press and hold the button for 3 seconds; the indicator lamp lights up = rinse aid and salt indicators are deactivated. From water hardness level 5, the salt indicator remains active. At the end of the programme, the most recently selected setting remains memorised. Fault indication and wash time display In normal operation it indicates the remaining time (h:min), whereas with “Delayed start” selected it indicates the time remaining until programme start (e. h 01)...