OVERVIEW Programme selection button Press the button (repeatedly) until the indicator lamp of the desired programme lights up (see table 1. At the end of the wash cycle, the last programme selected is memorized. Half Load/Multizone Load the upper or lower rack only. Factory setting = wash upper and lower rack (both indicator lamps light up) Press once = wash lower rack (the indicator lamp lights up) Press twice = wash upper rack (the indicator lamp lights up) At the end of the programme, the most recently selected setting remains memorised. If the upper rack is not being washed, the “Wash lower rack” indicator lamp should be lit. Power Clean This function is activated by pressing (short) the button (the indicator lamp lights up). High pressure with an additional jet for better washing results and greater bottom rack load flexibility. At the end of the programme, the most recently selected setting remains memorised. Detergent setting upon initial use and when using a different type of detergent Indicator lamp off = Powder/gel detergent (factory setting). If using combined detergents, press and hold the button for 3 seconds; the indicator lamp lights up = rinse aid and salt indicators are deactivated. From water hardness level 5, the salt indicator remains active. At the end of the programme, the most recently selected setting remains memorised. Fault indication and wash time display In normal operation it indicates the remaining time (h:min), whereas with “Delayed start” selected it indicates the time remaining until programme start (e. h 01). If using a sensor programme, a dotted line indicates that the calibration process is underway (lasting up to 20 minutes). In the presence of a fault indication “F. ”, refer to chapter 5. “What to do if. Delayed Start button Push the button (repeatedly) to delay the start of the programme...