Press and hold together Programs and CANCEL/Off buttons for minimum 3 seconds. Programs LEDs will indicate the water hardness setting. First time use Press the Programs button to increase setting (when the level reaches 7, the next key press will set the level back to 1. Wait 30 seconds (control panel switches off) or press START/Resume button to save setting. enter this value on your dishwasher 3 first PROGRAM LEDs lit on the panel (see table of programs) P1 P2 P3 1 2 3 4 5 6 7 go to step 1 (see “Daily check”) Suggestions for detergent use Gel or Powder (rinse aid and salt) Tablets 1. Ask your water supply company what the water hardness is. German degrees °dH 0-5 6 - 10 11 - 15 16 - 21 22 - 28 29 - 35 36 - 50 French degrees °fH 0-9 10 - 18 19 - 27 28 - 37 38 - 50 51 - 63 64 - 90 English degrees °eH 0 - 6. 3 7 - 12. 3 - 18. 6 - 25. 6 - 35 35. 7 - 44. 8 - 62. 4 Water hardness level Soft Medium Average Medium-hard Hard Very hard Extremely hard 10 9 1 4 if water is HARD extra salt needs to be added (go to step 1, “Daily check”) Filling the salt reservoir - Dissolve limescale (not necessary if water hardness level is set to “soft”!) Visual indicator (depending on the model). Unscrew cap. Daily check Screw on the cap. Salt residual around the cap need to be removed. Some salt reservoir have a level indicator integrated in the cap (see below how to check). 3 2 1 7 8 5 6 1- salt reservoir 2- rinse aid dispenser 3- detergent dispenser 4- racks system 5,6,7,8- available functions on the panel 9- filters 10- spray arms Fill the salt reservoir with water before the first wash only. Add salt (never add detergent!) min. 8 kg / max. 1 kg Once regeneration salt is added, immediately start a wash program (the “Pre-wash” program alone is not sufficient)...