Turn the programme selector to the “O” position. Close the water tap. Open the door and unload the machine. Leave the door ajar to allow the drum to dry. Press the “On/Off” button. CHANGING PROGRAMME AND/OR OPTIONS AFTER PROGRAMME START 1. Turn the programme selector to “O”. Select the new programme, any options and another spin speed if you want. Press the “Start” button again. The new programme resumes the wash programme from where the previous one was interrupted. Do not add detergent for this programme. CANCEL (RESET) A RUNNING PROGRAMME BEFORE THE END • Reset by turning the programme selector to “O” and select the “Drain Spin” programme to remove the water remaining in the bowl before the door can be opened. Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. In domestic use, consumption data may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. The time indicated on the display (if present) can deviate from the values in the table, because it takes into account the household * conditions applicable at that time. To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ** *** Reference programme for energy label. ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add detergent as indicated on the front page and as described in the chapter “Detergent and Additives” in the Instructions for Use. Press the “On/Off” button. Turn the programme selector to the desired programme. SELECT ANY DESIRED OPTION Press the button(s) of any required option(s) - the respective indicator lights up. When the combination of programme and additional option(s) is not possible, the indicators switch off automatically. Unsuitable combinations of options are deselected automatically...