At the end of the spinning cycle the drum goes on reversing for some minutes: this helps you unloading the laundry. Do not exceed in detergents dosage: excessive foam formation may prevent spinning. If you want to change the programme during the wash cycle, remember to switch the machine off before turning the programme selector knob. Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. The data on the “Energy Label” refer to the programme “Cotton 60°C”. DOOR LOCK During the running programme, the door cannot be opened. The door locks automatically in all programmes. If the programme is stopped or if an electrical power failure occurs, the door unlocks automatically after about 1 minute. PROGRAMME END • The programme selector knob is at “STOP”, the pilot lamp lights. Press the “On/Off” button, the pilot light goes out. Cancel the options by pressing the appropriate buttons. Turn the water supply tap off. Wait for the door to unlock (about 1 minute). Open the door and the drum flaps and unload the machine. SELECTING A NEW PROGRAMME, SPIN SPEED, OPTIONS AFTER PROGRAMME START 1. Press the “On/Off” button to switch off the appliance. The pilot light goes out. Select the new programme, temperature and options. Press the “On/Off” button to switch on the appliance. The pilot light lights. • PREPARATION OF WASH CYCLE 1. Close the drum flaps and check that they are properly locked...