Фрагмент инструкции: руководство пользователя WHIRLPOOL ADP-4730-WHПодробные указания по применению содержатся в руководстве пользователя. Switches off when the programme starts and indicates the time remaining in hours and minutes. ” Identification of faults for service technician
“Delayed start” button ON / OFF button
The wash cycle can be programmed to start after 1 24 hours. With each successive touch of the button, the delayed start indicator increases by 1 hour, and after 24 returns to 00. Then press the Start button. The dishwasher will start at the set time. “Half Load” button Start button
Switches “on” when the dishwasher is operating. Flashes when a fault occurs. Switches off at the end of the programme. The half load cycle can be used for the upper and lower rack. Select the required programme then press the “Half Load” button. The light comes on and goes off at the end of the programme. The “Half Load” function can be used with programmes marked with an *. Antibacterial rinse 4) This function adds an antibacterial rinse at the end of the wash cycle, thereby guaranteeing a perfectly clean and sanitized load. The lamp will light up when the function is activated. If the temperature is not maintained during the antibacterial cycle (e. if the door is opened and remains open for a long time), the lamp will start blinking to indicate that sanitation is not guaranteed. Indicators
Add regeneration salt
Only add regeneration salt immediately before starting a wash programme. Add rinse aid
Programme chart
Programmes Loading instructions
Detergent 2) A
X X X X X X
Consumption 3)
Litres
5. 0
B
X X X
kWh
0... |
Copyright © 2005 - 2012 - Diplodocs -
Все права защищены. Торговые марки принадлежат их соответствующим владельцам. |