Switch on the appliance Press the ON / OFF button. Compartment A: With each wash cycle. Compartment B: For programmes with pre-wash only. If using combined action dishwasher tabs, follow the user instructions! Mechanical indicator C. Electric indicator on control panel (if provided). A BC Fill the detergent dispenser Check the rinse aid level Check the regeneration salt level On models with water softener system only. Mechanical indicator D. Electric indicator on control panel (if provided). Load the racks Close the dishwasher door, turn on the water tap Select a programme Refer to the dishwasher loading instructions. The last programme selected will light up. Select the desired programme (using the specific button or knob). The corresponding indicator lamp lights up. If necessary (and if provided). The corresponding indicator lamp lights up. “Change programme in progress” Select additional options Press the Start button The selected programme is then memorised (even in the event of power failure). Press the START button for 2 sec. until the Start indicator lamp switches off. Select another programme and press the START button again. Wash cycle - Only open the dishwasher if necessary (Warning: beware of hot steam). - If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted. Only after the START button has switched off: Press the ON / OFF button. All the indicator lamps switch off. Warning: When the door is opened steam comes out! Unload the appliance, starting from the lower rack. Switch off the appliance Turn off the water tap, unload the racks Dishwasher loading instructions and racks provided Upper rack: Multi-purpose support (A): 1) Depending on the position, for longhandles utensils, cups and glasses. May be used in three different positions...