Press the OFF button. All the indicator lamps switch off. Turn off the water Unload the appliance, starting from the lower rack in order to avoid any tap, unload the racks residual drips of water falling onto crockery below. HOW TO USE THE APPLIANCE PROGRAMME SELECTION Press the button “Select programme” or the programme selector to display the selected programme. The appliance must be switched on. If required, select possible options. The corresponding indicator lights up. The correct programme and the selectable functions are given in table 1. 1 on page 1. Programme times stated in the table were obtained under normal conditions and may vary depending on conditions. Differences of up to 20 minutes are possible with sensor programmes as a result of the appliance's automatic calibration system. HOW TO FILL THE DETERGENT DISPENSER Only fill the detergent dispenser prior to starting a wash programme. Only use detergents specially recommended for dishwashers, observing the manufacturer's recommended dosage. Observe the manufacturer's safety warnings! Open the detergent dispenser compartments by pushing the left button (button 1) of the dispenser. Powder/gel/tabs Fill the detergent dispenser compartments in accordance with the wash programme selected (table 1. Programmes without pre-wash: pour the entire recommended dosage into compartment A. Programmes with pre-wash: pour 2/3 of the recommended dosage into the large compartment A and 1/3 into the small compartment B. Dishwasher tabs should be placed, according to the manufacturer's recommendations, in compartment A. If the “Half load” option is selected, detergent dosage should be reduced by approximately 1/3. Combined action detergents (2 in 1/3 in 1/. ) Large Combined action detergents should be placed, according to the compartment A manufacturer's recommendations, in compartment A...