Order from the supplies information sheet that is shipped with your printer. If a media jam occurs, the front panel reports Jam at . The are the various sensors throughout the paper path, listed as A through E. If you have an optional Lower Tray Assembly installed, Jam A can occur at any of the three media trays, whichever tray you selected for the current print job. The following illustration shows the locations of the sensors that report a media jam (A through E). Jam C, D A Jam A manual feed Jam A, B, C B Jam D D E Jam A Jam C Jam A Jam A Jam A 9008-60 Jam at A 1. Open the left side door corresponding to the selected media tray. Remove the selected media tray. Remove the jammed media from inside the printer. OR A4 PE PA R 1 9008-100 2. Remove the jammed media. 2 2 9008-49 9008-48 Note If you have an optional Lower Tray Assembly, Jam A can occur at any of the three media trays, whichever tray you selected for the current print job. Jam at B 1. Open the left side door corresponding to the selected media tray. Pull out the paper feeder; the jammed media is visible. Pull the media toward the inside of the printer. 3 9008-50 Jam at C 1. Open the left side door. Pull out the paper feeder. The media is on top of the paper feeder. Pull the media out toward the inside of the printer. Open the front door and the right side door to access the fuser. OR 9008-53 3 2. Turn the small blue knob counterclockwise to unlock the fuser; pull the fuser out until it stops. 9008-52 9008-99 3. Turn the fuser's large blue knob clockwise to release the jammed media. Remove the jammed media from the fuser. 3 4 9008-54 Jam at D 1. Open the front door to access the fuser...