Then go to page. 2 2 6 6 9 9 12 14 17 20 23 23 Phaser PX Phaser PXi Phaser II PX Phaser II PXi (slide-in style image processor board) Phaser II PXe Phaser II PXi (bolt-down style image processor board) Phaser III PXi and Phaser 300i Phaser II SX/DX (slide-in style image processor board) Phaser II SX/DX (bolt-down style image processor board) Phaser IISD/SDX Phaser 200i and 220i Phaser 200e and 220e Slide-in style image processor board (note the four thumbscrews) Bolt-down style image processor board Copyright © 1993 by Tektronix, Inc. All rights reserved. 063-1113-AH 4-Mbyte RAM SIMM Installation -- (4690F4M) Static electricity precautions s Leave the printer plugged into its power outlet. This preserves a ground path for static discharges. Touch the printer's bare metal frame often to discharge static electricity from your body. Handle the circuit board(s) by their edges only. Do not lay the board(s) on a metal surface. Make the least possible movements to avoid generating static electricity. Avoid wearing nylon or polyester clothing; they generate static electricity. s s s s s Phaser PX Phaser PXi 1. Power down the printer. Do not unplug the printer; this preserves a ground path to dissipate static charges. Disconnect the host interface cables. Remove the printer's upper half cover by first lifting the rear corners of the cover and then the front corners. 2 4-Mbyte RAM SIMM Installation -- (4690F4M) 3. Remove the EMI shield. 2 1 3 3 4-Mbyte RAM SIMM Installation -- (4690F4M) 4. PX image processor: Locate the RAM SIMM connector on the image processor board...