The document support should snap securely into place. Pull the paper output tray out of the paper tray cover. Document Output Tray Insert the document output tray into the two openings under the operation panel. Loading Paper Before your machine will be ready to make copies or receive faxes, you must load paper into the machine. Use paper letter, 8. 5 x 11 Inch (216 × 279 millimetres). Your machine works with normal copier paper and with typewriter paper (0. 13 ­ 0,2 lb/m2) (see user manual chapter Installation / Paper). 1 Separate the paper sheets by fanning them out, then align them by tapping edge of the stack lightly against a flat surface. This will prevent several sheets of paper from being drawn in all at once. Document input tray Document guide Document feed slot Cover Operation panel with LCD display Document output tray Paper output tray (extendable) Paper input tray Opening for Plug'n'Print card 2 Remove the cover from the paper tray. Put in only as much paper as will fit under the raised limit markers on the upper edge of the paper input tray (see also the drawings on the cover of the paper input tray). You can load up to 250 sheets into the paper input tray. 3 Press the paper down until the lever (A) snaps into place at the rear of the paper input tray. 4 Place the cover back on the paper input tray. Push the paper input tray into the machine all the way to the stopping point. II New Print Cartridge 1 Open the cover by taking hold of both document guides and tipping the cover backward. Æ 6 Once you have removed the protection strip, do not shake the print cartridge any more. Otherwise, it is possible that toner dust will be released into the air. Place the print cartridge into your machine. The cartridge should snap securely into position...