0 Server (TCP/IP) Quick Install Card Xerox Document Centre 240/255/265 LP/ST Before You Start If your printer is equipped with a Token Ring interface, use the Token Ring Quick Install Card supplied in this Quick Install Card set to set the Ring Speed and Source Routing settings for your environment. You can use DHCP or RARP servers to assign TCP/IP information to your Document Centre. Refer to the DHCP and RARP Quick Install cards for details. Record the following information IP Address ____________________________ Subnet Mask ___________________________ Default Gateway ________________________ You will compute your Broadcast Address as part of this procedure. button when finished. If your printer is an ST model press the Go to Tools button, otherwise skip to the next step. Set the Broadcast Address. a) Press the Broadcast Address button. b) The broadcast address can be calculated this way: Perform a logical OR of the IP address and the complement of the Subnet Mask. Example of logical OR method: IP Address = 13. 146 Subnet Mask = 255. 0 IP Address 00001101. 10101111. 01101101. 10010010 Complement of Subnet Mask 00000000. 00000000. 00000011. 11111111 The result 00001101. 10101111. 01101111. 11111111 Broadcast Address = 13. 255 c) The Touch Screen will be used for the 3. remainder of the data entry. Enter the Network Setup menus. a) Wait for the screen to refresh and press the Connectivity and Network Setup button. b) Wait for the screen to refresh and press the Network Setup button. c) Press the TCP/IP Options button. Enable the Protocol and Media. a) Press the TCP/IP Settings button. b) Press the Protocol and Media button. c) Press the Enable button. Once pressed the Physical Media buttons will appear. Select Ethernet or Token Ring. Press Save to retain the settings and continue...