X (or 4. 1X Bindery Mode) Quick Install Card Xerox Document Centre 240/255/265 LP/ST Before You Start If your printer is equipped with a Token Ring interface, use the Token Ring Quick Install Card supplied in this Quick Install Card set to set the Ring Speed and Source Routing settings for your environment. The CentreWare software supplied with your printer can be used to set up your printer on your Novell network. For details refer to the document entitled Getting Started with Admin Services. This procedure assumes you ran PCONSOLE to set up a print server. Please refer to the documentation supplied by Novell to complete this task. Record precisely (observe upper and lower case, punctuation etc. ) the following: Primary Server Name ____________________ Frame Type ____________________________ Print Server Name _______________________ Print Server password ____________________ Additionally, you must set the NCP packet signature option to 0,1, or 2 (3 is not supported), AND set Reply to get nearest server to ON for at least one file server that is on the same segment as the printer. NOTE: ALL Print Servers you create must have a password. When your printer will service queues on multiple fileservers, the Print Server name must be the same on all fileservers and the Print Server password must be the same on all fileservers. e) Press the Enable button. Once pressed the Physical Media buttons will appear. Select Ethernet or Token Ring. Press Save to retain the settings and continue. Set the Primary File Server Go to the printer and. a) Press the Primary File Server button. b) Press the upper-left keyboard icon button on the Touch Screen to set the first Primary File Server. Connect your Document Centre to the network with the appropriate cabling. Enter the Tools pathway. a) Press the Access ( ) button. b) On the keypad enter 1111 or the current password. Press the Enter button when finished...