Enter System Administrator Setups: 5. a) Press the [Access] button on the Control Panel. Select the appropriate interface for your network: a) Press [Interface]. b) Ethernet is displayed. Before Installation: Use the Banyan VINES MANAGE utility to: · · · · Create a StreetTalk Name and Password for the DC220/230. Create a Print Service Name for the DC220/230. Set the Destination to the StreetTalk Name. The Destination Type for the DC220/230 should be set to PCPRINT. b) Enter the System Administrator password by typing #22222 (# key and 22222) on the keypad and pressing [Enter] on the screen. Note: #22222 is the factory default password and may be changed by your Xerox service representative to suit your needs. Enter the StreetTalk Name: a) Press [StreetTalk Name]. b) Press [Edit] and use the keyboard on the screen display to enter the full assigned name exactly as it was previously entered. Example: (StreetTalk Name)@ (Group)@(Organization) could be Printer1@DSSC@XRX. Note: Additional characters are available by pressing the Change Keyboard button in the upper right corner of the screen. Access the Network Setups screen: a) On the screen display, press [Print Setups]. Record the following information for use during setup at the DC220/230: StreetTalk Name:________________________ StreetTalk Password:_____________________ Print Service Name:______________________ b) Press [Network Setups]. c) Press [Additional Setups] at the top right of the screen display. c) Press [Save]. d) Press [Banyan VINES]. Enable Banyan VINES: a) Press [Enablement]. Connect the DC220/230 to your network outlet or cable. b) Press [Enabled]...