1x Bindery Quick Install Installation Requirements: Frame Type:____________________________ If this is a Token Ring installation, the Token Ring card must be installed by your Xerox service represenvative and configured before performing this procedure. Refer to the Token Ring Quick Install card. If running NLSP, be sure that RIP/SAP compatibility is configured on the same segment as the DC220/230. Note: For a NDS installation, refer to the NetWare 4. x NDS Quick Install card. Poll Interval:____________________________ 4. Enable NetWare: a) Press [Enablement]. b) Press [Enabled]. Connect the DC220/230 to your network outlet or cable. Enter System Administrator Setups: 5. Select the appropriate interface and frame type for your network. a) Press the [Access] button on the Control Panel. a) Press [Interface]. b) On the right half of the screen, select [Ethernet] or [Token Ring] as the appropriate interface for your network. Note: Token Ring will not be available as a selection unless it has been installed and configured. b) Enter the System Administrator password by typing #22222 (# key and 22222) on the keypad and pressing [Enter] on the screen. Note: #22222 is the factory default password and may be changed by your Xerox service representative to suit your needs. Before Installation: · Perform the network installation for the printer using the appropriate NetWare utility (PCONSOLE). c) Select the appropriate frame type for your network: IEEE_802. 3, Ethernet II, or IEEE_802. IMPORTANT: During the next two steps, be sure that the Print Server name and the Print Server Password are exactly the same as the values entered in PCONSOLE. Note: Define the printer as Defined Elsewhere or Remote/Other. · Record the following information for use during setup at the DC220/230: 3. Access the NetWare Setup screens: a) On the screen display, press [Print Setups]...