Do not attach cables to more than one Ethernet connector; only one Ethernet connection can be made at any one time. Parallel cable connection The DocuColor 2006 can also accept print jobs from a Windows computer through its high-speed, bi-directional parallel port. This connection is useful for portable computers and for workstations that use dedicated networks using protocols other than AppleTalk, TCP/IP, or IPX. Parallel port connections can be used simultaneously with network connections. The parallel port accepts a standard Centronics-type (IEEE-1284) printer cable. The diagrams on the following pages illustrate typical system installations. Refer to the page with your preferred platform and network type. For actual installation and setup, refer to the chapters that are appropriate to your system. 5­4 Xerox DocuColor 2006 5. Connecting to the network The illustrations are logical diagrams and are not intended to describe the physical arrangement (topology) of devices on the network. A variety of physical arrangements is possible with each logical arrangement. If the network uses more than one protocol or more than one type of workstation, combine the setups listed for each component of your system. Multiple protocols (illustrated as parallel lines) can run on the same cable. A solid connection from the printer with an arrow indicates that other supported network types can be operational at the same time. The IPX/SPX and TCP/IP functionality outlined in this section is available on both Ethernet and Token Ring networks. AppleTalk is supported on Ethernet only. The protocols used in these diagrams are illustrated as follows: IPX (Novell) AppleTalk TCP/IP (lpd, nbt, or http) Parallel Other Xerox DocuColor 2006 5­5 5...