Read all the instructions before performing this procedure. Contents of kit: · Feed Roll Cleaning Pad · Repair Instructions CUSTOMER PREPARATION: · Unpack the repair kit and read the Repair Instructions. NOTE: Good lighting is required in order to see inside the WorkCentre 450c / 450cp F ü q 1. Check off the box after each Step is completed. Step 1: Remove all paper and the clear plastic Printer Output Tray Printer Output Tray q q q Remove all paper and the clear plastic Printer Output Tray in front of the paper tray. (See Figure 1) Insert approximately a ¼ inch thick stack of ¼ inch Paper Stack 20 lb. paper (measure it) into the Paper Tray. Insert the Feed Roll Cleaning Pad (provided in Feed Roll Cleaning Pad with the green side facing out Kit) in front of the paper stack (Long-Edge-Down) with the green side (coarse side) facing out. Step 2: Insert approximately a ¼ inch thick stack of paper into the Paper Tray and insert the Feed Roll Cleaning Pad in front of the paper stack with the green side facing out (continued) Bottom of Paper Tray 3 Feed Rolls are in front of the Pad 709P00850 Rev A March 2000 DRB-FILE Figure 1. Inserting the Feed Roll Cleaning Pad into the Paper Tray Page 1 of 2 Feed Roll Cleaning Kit 4. q Press the Feed button for approximately one second and release (See Figure 2). This will engage the feed rollers for a short period of time and allow the Feed Roll Cleaning Pad to clean and restore the surface texture of the feed rollers. Repeat this process approximately 10 times. Step 1: Press the Feed button for approximately one second and release...