20 Appendix A: Print the Configuration Sheet. 22 For Phaser networked printers. 22 Appendix B: Set an IP Address. 23 For Phaser networked printers. 23 Introduction The purpose of this document is to provide an experienced Systems Administrator with information for setting up the Phaser 1235 printer on the various networks indicated. Requirements In general, the requirements needed for printer connection and setup include: I I A workstation with the appropriate operating system software installed for that station. A working knowledge of your network. Additional information Additional information may be found in on-line help and electronic documentation supplied with your printer. This documentation may include an Advanced Features and Troubleshooting Manual on the printer CD-ROM for most printers and a Technical Information Guide on the Printer Management Software CD-ROM. How to use this document This document has been arranged to get the printer set up on your network quickly and with minimum reading. Review the Table of Contents. Find the Network Operating Systems (NOS), which pertains to your network. Go to the page indicated and perform the procedure. The procedure may point you to one or more of the Appendices located in the back of this document. Once these procedures are finished it is recommended you print a Test Print. Check the print job for print-quality. If print-quality problems exist, use the Troubleshooting section of your printer's Advanced Features and Troubleshooting Manual to correct the problem...