For more information, please consult your local retailer. English The following illustration shows a typical installation. 1710-99 1. If the printer is on, turn it off. Connect one end of an Ethernet cable to the Ethernet port on the printer. Connect the other end of the cable to the hub. (Do not connect the cable to a port on the hub labeled Uplink. ) Turn on the printer. Refer to the software setup instructions for your environment. The Ethernet hub shows the status of devices through indicator lights. There are also two green indicator lights on the back of the Phaser 3400 printer, next to the network cable. The top indicator light should always be on when the printer is on; it indicates a live connection to the network. The lower indicator light should be blinking; it indicates that the network card is active. 2 Phaser 3400 Personal Laser Printer Printing a Configuration Sheet To see the IP address assigned to the printer, print the Configuration Sheet: 1. Make sure that the printer is on and connected to your network. English Hold down the Print button (on the top of the printer) until all four lights blink. Release the button. Software Setup - Windows Environment Make sure that your computer has TCP/IP for Windows and is set to obtain an IP address automatically. Note If you administer a network where you assign a specific IP address to each of the network computers and each of the network devices, refer to the Phaser 3400 Personal Laser Printer Network Guide (on the CD-ROM) for more information. Installing TCP/IP and Checking Settings Windows 9x and Me 1. Click Start, select Settings, then click Control Panel. Double-click the Network icon...