2 Installation Instructions Warning: If you have an HFT controller with AccXES 8. 0 or 8. 5, upgrading to AccXES 9. 0 will cause you to lose the following Data Format Interpreters (DFI): · VCGL · Versatec Raster (VRF & VDS) · CGM These DFIs are no longer part of the standard system. A feature key is necessary to enable them. The DFI Feature Keys can be purchased through Xerox Sales or an Authorized Reseller. See Step 1 to determine if you have the appropriate controller. Note: For the Xerox 6050 and 6030 Wide Format products, one must activate the AccXES print server by downloading the appropriate print server feature key. Warning: If the current AccXES Version is 8. 0 or lower, upgrading to AccXES 9. 0 will eliminate all existing feature keys. Once installation is complete, you will need to reinstall your feature keys. If you are currently at AccXES 9. 0 or greater, your feature keys will be retained. Determine your Hardware Configuration There are distinct versions of firmware for each controller hardware platform. Firmware is available for the hardware platforms as indicated below. Your hardware platform can be determined by examining the printer configuration test print or serial number (found on the AccXES controller unit). Note your hardware version. Note: Use the HFT firmware as this will be the correct downloadable binary for PUN controllers. Controller PUN HFT CPU from Test Print RTT-MPC 7410 RTT-MPC 7410 Serial Number PUN-XXXXX HFT-XXXXX Step 1 Step 2 Step 3 Release Notes Download, print, and read the AccXES release notes (pdf format). The release notes can be found in the documentation section or by using the `See Also' link. Check Disk Size and RAM Requirements Consult the Recommended Configurations Chart in the AccXES Release Notes to confirm that your Controller has the required disk size and RAM needed for the AccXES upgrade. This chart can be found in the documentation section or by using the `See Also' link...