Скачать инструкцию



Фрагмент инструкции: руководство пользователя JBL GT5-A402

Подробные указания по применению содержатся в руководстве пользователя.

· At the installation sites, locate and make a note of all fuel lines, hydraulic brake lines, vacuum lines and electrical wiring. Use extreme caution when cutting or drilling in and around these areas. · Choose a safe mounting location away from moisture. · Make sure there is sufficient air circulation at the mounting location for the amplifier to cool itself. · Mount the amplifier, using the supplied hardware. Specifications · 40W RMS x 2 @ 4 ohms and 1% THD + N* · 60W RMS x 2 @ 2 ohms, 14. 4V supply and 1% THD + N* · 120W RMS x 1 @ 4 ohms, 14. 4V supply and 1% THD + N* · Total peak power: 240 watts · Frequency response: 10Hz ­ 100kHz (­3dB)* · Maximum input signal: 6V* · Maximum sensitivity: 200mV* · THD + N: 0. 05% · Signal-to-noise ratio: 85dBA (reference 1W into 4 ohms)* · Signal-to-noise ratio: 101dBA (reference rated power into 4 ohms) * CEA-2006A-compliant 0 Speaker Output Connectors · Connect the speakers to these terminals, observing proper polarity. · Two-channel operation: Connect the left speaker to the L+ and L­ terminals and the right speaker to the R+ and R­ terminals. · One-channel (bridged) operation: Connect the single speaker to the R+ and L­ terminals. · Minimum speaker impedance for 2-channel operation is 2 ohms. Minimum speaker impedance for 1-channel (bridged) operation is 4 ohms. 1 Fuse · Replace only with the same type and rating. 2 Power Input Connectors · +12V: Connect to the positive terminal of the vehicle's battery. 10 AWG wire is recommended. Install an appropriate fuse holder and fuse (15A minimum) within 18 inches of the battery. Make sure the wire is not damaged or pinched during installation...
Copyright © 2005 - 2012 - Diplodocs - Все права защищены.
Торговые марки принадлежат их соответствующим владельцам.