Скачать инструкцию



Фрагмент инструкции: руководство пользователя JBL GTO752

Подробные указания по применению содержатся в руководстве пользователя.

· At the installation sites, locate and make a note of all fuel lines, hydraulic brake lines, vacuum lines and electrical wiring. Use extreme caution when cutting or drilling in and around these areas. · Choose a safe mounting location away from moisture. · Make sure there is sufficient air circulation at the mounting location for the amplifier to cool itself. · Mount the amplifier, using the supplied hardware. Specifications · 75W RMS x 2 channels @ 4 ohms and 1% THD + N* · 110W RMS x 2 channels @ 2 ohms and 1% THD + N* · THD + N: 0. 07% (rated power @ 4 ohms) · Signal-to-noise ratio: 90dBA (reference 1W into 4 ohms)* · Signal-to-noise ratio: 108dBA (reference rated power into 4 ohms) · Frequency response: 10Hz ­ 100kHz (­3dB) · Max power: 220 watts * CEA-2006A-compliant 0 Speaker Output Connectors · Connect the speakers to these terminals, observing proper polarity. · Two-channel operation: Connect the left speaker to the L+ and L­ terminals and the right speaker to the R+ and R­ terminals. · One-channel (bridged) operation: Connect the single speaker to the R+ and L­ terminals. · Minimum speaker impedance for 2-channel operation is 2 ohms. Minimum speaker impedance for 1-channel (bridged) operation is 4 ohms. 1 Fuses · Replace only with the same type and rating. 2 Power Input Connectors · +12V: Connect to the positive terminal of the vehicle's battery. 10 AWG wire is recommended. Install an appropriate fuse holder and fuse (30A minimum) within 18 inches of the battery. Make sure the wire is not damaged or pinched during installation. Install protective grommets when routing wires through the firewall or other sheet metal. · GND: Connect to the vehicle's chassis...
Copyright © 2005 - 2012 - Diplodocs - Все права защищены.
Торговые марки принадлежат их соответствующим владельцам.