Скачать инструкцию



Фрагмент инструкции: руководство пользователя HAIER HSU24VHJ-DB-

Подробные указания по применению содержатся в руководстве пользователя.

Not affected by heat or steam generated in the vicinity, where inlet and outlet of the unit are not disturbed. Possible to drain easily, where piping can be connected with the outdoor unit. Where cold air can be spread in a room evenly. Nearby a power receptacle. (Refer to drawings). Place where the distance of more than lm from televisions, radios, wireless apparatuses and fluorescent lamps can be left. In the case of fixing the remote controller on a wall, place where the indoor unit can receive signals when the fluorescent lamps in the room are in use. Power Source Before inserting power plug into receptacle, check the voltage without fail. The power source is the same as the corresponding name plate. Install an exclusive branch circuit of the power. A receptacle shall be set up in a distance where the power cable can be reached. Do not extend the cable by cutting it. Outdoor Unit - Select a location that is Less affected by rain or direct sunlight and is sufficiently ventilated. Strong enough to bear the unit, where vibration and noise are not increased. Not causing a nuisance to neighbors due to discharged air or noise. A distance marked Q is available as illustrated in the below figure. Drawing for the installation of indoor and outdoor units The models adopt HC FC free refrigerant R410A Attention must be paid to the pitch of drain hose more than 10cm (3 7/8) Optional parts for piping A Non-adhesive tape B Adhesive tape more than 10cm (3 7/8) G C Saddle (L...
Copyright © 2005 - 2012 - Diplodocs - Все права защищены.
Торговые марки принадлежат их соответствующим владельцам.