Necessary Tools for Installation 1. Driver 2. Hacksaw 3. Hole core drill 4. Spanner(17,19 and 26mm) 5. Torque wrench(17mm,22mm,26mm) 6. Pipe cutter 7. Flaring tool 8. Knife 9. Nipper 10. Gas leakage detector or soap-and-water solution 11. Measuring tape 12. Reamer Drawing for the installation of indoor and outdoor units Accessory parts No. 1 2 3 Mounting plate more than 5cm Accessory parts Remote controller Number of articles 1 2 1 1 6 4 1 4 1 1 Optional parts for piping Mark A B C D E F G Parts name Non-adhesive tape Adhesive tape Saddle(L. S) with screws Connecting electric cable for indoor and outdoor Drain hose Heating insulating material Piping hole cover mo re th a n1 0c m R-03 dry battery mo re tha n1 0c m 4 5 6 7 8 9 10 Drain hose 4X50 Steel nail, cement 4X25 Screw Plastic cap Cover Cushion Attention must be paid to the rising up of drain hose A C Arrangement of piping directions mo re tha n1 Rear left Left Rear right Below Right 0c m h re t mo 1 an 0cm Pipe supporting plate Drain-elbow D E more than 6 0c m mor e th an 1 5c m The marks from A to G in the figure are the parts numbers. The distance between the indoor unit and the floor should be more than 2m. 0010518785 113. 5 583 113. 5 319. 5 113. 5 633 113. 5 HSU-24LEB03(T3) HSU-24LEA13-M (microchannel heat-exchanger) Floor fixing dimensions of the outdoor unit (Unit:mm) 334...