Скачать инструкцию



Фрагмент инструкции: руководство пользователя BLAUPUNKT TRAVELPILOT-RNS3-FH-LATIN-1

Подробные указания по применению содержатся в руководстве пользователя.

To prevent damage to your TravelPilot, be sure to use the correct adapter cable to connect the vehicle 8-pin +/- ISO plug. 2 Information on proper functioning To ensure that the TravelPilot functions properly, it is essential that the system be calibrated after it has been completely installed (see Operating instructions / Contents / Calibration). The system determines the distance travelled via its connection to the vehicle speedometer signal. If there is no speedometer signal, it will be necessary to have a route sensor mounted by an authorised customer service centre. In this case you will have to order a sensor kit (route sensor, magnet strip, bracket and plug) from your dealer. Order-No. : 7 607 611 093 Fiat, Honda, Lancia, Mercedes, Peugeot, Porsche, Renault, Skoda. For other vehicles with vehicle ISO plugs, use the vehicle-specific ISO adapter cables, e. for Audi, Skoda, VW with active antennas (Order-No. 7 607 621 129) (see Fig. ­ 1. 2 Power connection to vehiclespecific plugs If the radio connection in your vehicle was fitted with a 10A fuse at the factory (see operating instructions or the fuse box in your car. ), you will still need the vehicle-specific adapter cable (see Fig. Observe the following safety information while installing and connecting the system: ­ ­ Disconnect the negative terminal of the battery. In doing so, observe the safety information provided by the vehicle manufacturer. Make sure not to damage any vehicle parts when you drill holes. The cross-section of the positive and negative wiring must not be less than 1. 5 mm2. Use wire bushings for sharp-edged holes. The TravelPilot can be used in vehicles with: · 12 V battery power · Negative pole on the chassis 2...
Copyright © 2005 - 2012 - Diplodocs - Все права защищены.
Торговые марки принадлежат их соответствующим владельцам.